Can a Power Station Run a Well Pump?
Most well pumps run on 240 volts, which rules out most portable power stations.
Only a 120/240-volt power station like the EcoFlow Delta Pro 3 or Anker SOLIX F3800 Plus can run a typical 240-volt submersible well pump, usually through a transfer switch, while a few shallow-well and jet pumps run on 120 volts and work with large 120V stations.
Check the voltage first
Look at the breaker for your well pump. A double-pole breaker (two linked switches) means 240 volts. Most deep-well submersible pumps are 240V. Some shallow-well jet pumps run on 120V.
Start-up surge
A 1/2 hp well pump may run at about 1,000 watts but need two to three times that to start; a 1 hp pump can need 4,000 watts or more for a moment. The control box or pump label lists running and locked-rotor (starting) amps. A soft starter made for well pumps lowers the start-up draw and can make a smaller station work.
| Station | Voltage | Output | Surge |
|---|---|---|---|
| EcoFlow Delta Pro 3 | 120/240V | 4,000W | 8,000W surge |
| Anker SOLIX F3800 Plus | 120/240V | 6,000W | 6,000W max |
| Jackery HomePower 3000 | 120V | 3,600W | 7,200W peak |
Connecting it
Well pumps are hardwired, so you need a transfer switch or a generator inlet with an interlock, installed by an electrician, and a station with a 240V L14-30 outlet. See connecting a power station to your house.
How much energy
A well pump only runs when the pressure tank needs refilling. A household might run it 30 to 60 minutes total a day, so at 1,000 watts that's about 0.5 to 1kWh a day: well within a 4kWh station alongside a fridge.
EcoFlow Delta Pro 3
- Price
- About $2,400
- Capacity
- 4,096Wh
- Output
- 4,000W, 120/240V
- Recharge
- About 50 min to 80% on 240V; 1,800W on 120V
- Weight
- 113.5 lb
Anker SOLIX F3800 Plus
- Price
- About $2,300
- Capacity
- 3,840Wh
- Output
- 6,000W, 120/240V
- Recharge
- 1,800W from a wall outlet, about 2.5 hrs
- Weight
- 136.7 lb
Questions
Can a Jackery run a well pump?
The HomePower 3000 can run a 120V well pump within its 3,600 watts, but not a 240V pump.
How big a power station do I need for a well pump?
For a 240V 1/2 hp pump, a 120/240V station with at least 3,000 to 4,000 watts of output and a matching surge rating.